REMOVING blood
1. Rinse with Cold Water - Flush the stain from the back with cold water to prevent setting.
2. Soak with OxyBoost - Dissolve 2 scoops of OxyBoost in a tub or basin of hot water. Submerge the stained garment and soak for 1–6 hours (or overnight for tough stains).
3. Agitate Lightly - Gently rub the stained area or swirl the fabric in the solution to help lift the blood occasionally.
4. Wash As Usual - Wash with Truly Free Home Laundry Wash. Avoid the dryer until the stain is fully gone.
Tips:
- Avoid rubbing harshly, which can damage fibers.
- Repeat steps if needed.
1. Rinse with Cold Water - Run cold water through the stained area from the back to loosen the blood.
2. Make an OxyBoost Soak - Dissolve 2 scoops of OxyBoost in 1–2 gallons of hot water in a bathtub, sink, or bucket.
3. Soak the Sheets - Submerge the stained section (or the whole sheet) and let soak for 1–6 hours, or overnight for dried stains.
4. Gently Agitate - Swish the sheet in the water or lightly rub the fabric to help release the stain occasionally.
5. Wash as Usual - Wash with Truly Free Home Laundry Wash in cold water. Skip the dryer until the stain is gone.
Tips:
- Avoid rubbing harshly, which can damage fibers.
- Repeat steps if needed.
1. Prepare a Soak - Dissolve 2 scoops of OxyBoost in hot water in a bowl, sink, or bucket.
2. Soak the Fabric - Submerge the fabric and soak for 1–6 hours (overnight for dried or deep stains).
3. Gently Agitate - Occasionally swish the item in the water or gently rub the stain to help lift it.
4. Wash As Usual - Wash with Truly Free Home Laundry Wash in cold water. Air dry and check for any stain before using heat.
Tips:
- Avoid rubbing harshly, which can damage fibers.
- Repeat steps if needed.
1. Rinse with Cold Water - Rinse the back of the stain with cold water to flush out as much blood as possible.
2. Dampen & Apply - Wet the stained fabric and the Stain Stick, then rub the stick directly onto the stain.
3. Let It Sit - Allow it to sit for 5 minutes.
4. Agitate Gently - Rub fabric together or use a soft brush to help loosen the stain.
5. Rinse & Wash - Rinse well with cold water, then wash with Truly Free Home Laundry Wash. Air dry—avoid heat until the stain is gone.
Tips:
- Avoid rubbing harshly, which can damage fibers.
- Repeat steps if needed.
1. Blot the Stain - Use a clean cloth or paper towel to blot up as much of the blood as possible. Do not rub, as this can push the stain deeper into the fabric.
2. Spray the Stain - Spray Odor & Stain Eliminator generously over the blood-stained area until fully saturated.
3. Let It Soak In - Allow the formula to sit for 10–15 minutes to break down the blood proteins and lift the stain.
4. Blot Again - Blot the area with a clean cloth to lift the stain and moisture. Repeat spraying and blotting if needed for deeper or dried stains.
5. Air Dry - Let the furniture air dry completely.
Tips:
- Avoid rubbing harshly, which can damage fibers.
- Repeat steps if needed.
- Test in an inconspicuous place if desired for color fastness.
1. Blot the Area - Use a clean towel or paper towel to blot up as much blood as possible. Avoid rubbing—this spreads and sets the stain deeper.
2. Spray Thoroughly - Saturate the blood-stained carpet area with Odor & Stain Eliminator.
3. Let It Sit - Allow it to soak for 10–15 minutes to break down the stain.
4. Blot Again - Use a clean cloth to blot the area and absorb the lifted stain. Repeat as needed for tough or dried stains.
5. Rinse & Dry (Optional)
Lightly blot with a damp cloth to remove residue if desired. Let it air dry completely.
Tips:
- Avoid rubbing harshly, which can damage fibers.
- Repeat steps if needed.
- Test in an inconspicuous place if desired for color fastness.
1. Blot Immediately - Use a clean cloth or paper towel to blot (not rub) the blood. This prevents spreading and pushing it deeper into the fabric.
2. Spray the Area - Spray the Odor & Stain Eliminator generously over the stained area until it’s well-saturated.
3. Let It Sit - Allow the product to soak for 10–15 minutes to break down and lift the stain.
4. Blot Again - Use a clean, damp cloth to blot the area and absorb the lifted stain and product.
5. Air Dry - Allow the couch to air dry fully.
Tips:
- Avoid rubbing harshly, which can damage fibers.
- Repeat steps if needed.
- Test in an inconspicuous place if desired for color fastness.
1. Blot the Stain - Use a clean, dry cloth or paper towel to blot up any excess blood. Do not rub, as this can spread and set the stain.
2. Apply the Odor & Stain Eliminator - Spray the Odor & Stain Eliminator directly onto the stained area until fully saturated.
3. Let It Sit - Allow it to soak into the fabric for 10–15 minutes to break down the stain.
4. Blot Again - Use a clean, damp cloth to blot and lift the stain and excess product. Repeat if necessary for deeper or dried stains.
5. Air Dry - Let the upholstery air dry completely. Avoid heat or fans until you confirm the stain is fully gone.
Tips:
- Avoid rubbing harshly, which can damage fibers.
- Repeat steps if needed.
- Test in an inconspicuous place if desired for color fastness.